[Pacemaker] Slave didn't become master after master is down

[邓尧]

I followed this manual:
http://clusterlabs.org/doc/en-US/Pacemaker/1.1-pcs/html/Clusters_from_Scratch/index.html,
except the pcsd installation, as it's unavailable on my CentOS 6.5 box. I
also installed cman, because without it, command "pcs cluster start" would
fail. Two resources were added to the cluster: a DRBD device and a
filesystem resource, the resource setup steps are the same as written in
the manual.

Property "stonith-enabled" was set to false, "no-quorum-policy" was set to
ignore.

Everything seems to be fine until I tried to test failover:
If I "standby" the master, the slave became master for a very short while
(about one or two seconds), then it become slave, however after I unstandby
the original master, the slave then became a master, and the original
master became slave. The behaviour is illustrated as the graph:

node0(master)  node1(slave)  <== the original state.
====================
node0(slave)  node1(master)   <== after command "pcs cluster standby node0"
=====================
node0(stopped) node1(slave)  <== after a short while
====================
node0(slave) node1(master)  <== after command "pcs cluster unstandby node0"

I also tried rebooting the master node, the slave only became master after
the original master is successfully rebooted.
What's most likely cause of my problem ?

Thanks
Deng Yao
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.clusterlabs.org/pipermail/pacemaker/attachments/20140227/4657b7fd/attachment-0002.html>