[Pacemaker] pacemaker kills corosync

[Olivier Nicole]

Hi Max,

> Normally pacemaker is loaded by Corosync, ie you just start corosync
> and leave pacemaker stopped and disabled via chkconfig. This is set
> in corosync.conf by this:
> 
> service {
>         # Load the Pacemaker Cluster Resource Manager
>         name: pacemaker
>         ver:  0
> }
> 
> http://www.clusterlabs.org/doc/en-US/Pacemaker/1.1/html/Clusters_from_Scratch/s-configure-corosync.html

Yes, I followed this HowTo, but it mentions that the directive service
{} should be in /etc/corosync/service.d/pcmk, not in
/etc/corosync/corosync.conf

And it also mention in the note at the bootm that pacemaker is not
started automatically by corosync, that it will have to be started
later by /etc/init.d/pacemaker start in part 3.2 of the HowTo.

Thank you,

Olivier

> Do you have this set?
> Max
> 
> -----Original Message-----
> From: Olivier Nicole [mailto:Olivier.Nicole at cs.ait.ac.th] 
> Sent: 05 October 2011 12:11
> To: Pacemaker at oss.clusterlabs.org
> Subject: [Pacemaker] pacemaker kills corosync
> 
> Hi,
> 
> I am new to pacemaker. I want to set-up a small cluter to provide high availability for NFS. The disk sharing is taken care off.
> 
> I am trying to figure out how to configure/run corosync and pacemaker.
> 
> My test plateform is CentOS 6.0, with pacemaker installed from the packages.
> 
> [root at cos3 log]# pacemakerd --version
> Pacemaker 1.1.2
> Written by Andrew Beekhof
> [root at cos3 log]# corosync -v
> Corosync Cluster Engine, version '1.2.3' SVN revision 'exported'
> Copyright (c) 2006-2009 Red Hat, Inc.
> 
> It seems that corosync is working fine, but whenever I try to start pacemakerd, the corosync process dies and I get nothing in any log.
> 
> I am completely lost.
> 
> Best regards,
> 
> Olivier
>