[Pacemaker] two nodes fenced when drbd link fails

[Dejan Muhamedagic]

Hi,

On Thu, May 13, 2010 at 07:37:31PM +0200, Ivan Coronado wrote:
> Hello to everybody,
>  
> I have a problem with the corosync.conf setup. I have a drbd service
> runing on eth3, and a general network and the stonith device (idrac6) in
> the eth0. If I unplug the eth3 to simulate a network failure two nodes
> are fenced (first the slave followed by the master). If I only leave
> ringnumber 0 in the coroync.conf file I don't have this problem. Is this
> normal operation?

No, but one can't say without looking at the logs what happened.

Thanks,

Dejan

> Here you have the section of corosync.conf where I have the problem, and
> thanks for the help.
>  
>         rrp_mode: active
>         interface {
>                 # eth0
>                 ringnumber: 0
>                 bindnetaddr: 200.200.201.0
>                 mcastaddr: 226.94.1.1
>                 mcastport: 5405
>         }
>         interface {
>                 #eth3
>                 ringnumber: 1
>                 bindnetaddr: 192.168.2.0
>                 mcastaddr: 226.94.1.2
>                 mcastport: 5406
>         }
> 
> -----
> Ivan

> _______________________________________________
> Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> 
> Project Home: http://www.clusterlabs.org
> Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf