[Pacemaker] Restart Stonith-resource

[Ingmar]

thx Andreas

I found both attributes / properties...
I configured for both stonith-resources the meta-attribute "failure-timeout" 
and set them to 60s... is this ok or what value should I use.
Is this attribute also recommended for other resources?

What is a good value for the "cluster-recheck-interval"? And what exactly is 
the effect of this change?

regards,
Ingmar

"Andreas Kurz" <andreas.kurz at linbit.com> 
schrieb im Newsbeitrag news:6259.15623172677$1272620889 at news.gmane.org...
> On Thursday 29 April 2010 18:16:33 Ingmar wrote:
>> Hi,
>>
>> during testing, the failure scenarios I've found the following:
>>
>> If I e.g. the network of my stonith device will disconnect it noticed by
>>  pacemaker and the resource is stopped and set to faulty. Is there a
>>  setting that the resource will start again once the device is accessible
>>  again?
>
> configure the meta attribute "failure-timeout" for your stonith-resources 
> and
> you may want to lower the value of the cluster property "cluster-recheck-
> interval" from the default 15min (a cluster restart is needed for this to 
> take
> affect)
>
> Regards,
> Andreas
>
> _______________________________________________
> Pacemaker mailing list: 
> Pacemaker at oss.clusterlabs.org
> http://oss.clusterlabs.org/mailman/listinfo/pacemaker
>
> Project Home: http://www.clusterlabs.org
> Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
>